Module regs
- AuxdatadmaAmount
- Description cluster: Number of 32-bit words transferred in the last transaction.
- AuxdatadmaMaxcnt
- Description cluster: Maximum number of 32-bit words to transfer.
- Ccactrl
- IEEE 802.15.4 clear channel assessment control.
- CfoStat
- Carrier freq. offset estimate.
- Clearpattern
- Clear the GPIO pattern array for antenna control.
- Cnf
- Description collection: AUXDATA configuration.
- Crccnf
- CRC configuration.
- Crcinit
- CRC initial value.
- Crcpoly
- CRC polynomial.
- Crcstatus
- CRC status.
- CstonesMode
- Selects the mode(s) that are activated on the start signal.
- Cteinlineconf
- Configuration for CTE inline mode.
- Ctestatus
- CTEInfo parsed from received packet.
- Currentamount
- Number of bytes transferred in the current transaction.
- Dacnf
- Device address match configuration.
- Dai
- Device address match index.
- Dap
- Description collection: Device address prefix n.
- Datawhite
- Data whitening configuration.
- Dbccorr
- Correlator thresholds.
- Dfectrl1
- Various configuration for Direction finding.
- Dfectrl2
- Start offset for Direction finding.
- Dfemode
- Whether to use Angle-of-Arrival (AOA) or Angle-of-Departure (AOD).
- DfepacketAmount
- Number of bytes transferred in the last transaction.
- DfepacketMaxcnt
- Maximum number of bytes to transfer.
- Dfestatus
- DFE status information.
- Downsample
- Turn on/off down sample of input IQ-signals.
- Edctrl
- IEEE 802.15.4 energy detect control.
- Edsample
- IEEE 802.15.4 energy detect level.
- Enable
- Description cluster: Enable or disable data acquisition.
- Faepeer
- FAEPEER (Frequency Actuation Error) of peer if known. Used during Mode 0 steps.
- Feconfig
- Config register.
- Ffoest
- FFO estimate.
- Freqfinetune
- Fine tuning of the RF frequency.
- Freqoffset
- Frequency offset estimate.
- Frequency
- Frequency.
- Int0
- Disable interrupt.
- Int1
- Disable interrupt.
- Iqrawmean
- Mean of IQ values.
- Magphasemean
- Mean magnitude and phase of the signal before it is converted to PCT16.
- Magstd
- Magnitude standard deviation approximation.
- Nextfrequency
- The value of FREQUENCY that will be used in the next step.
- Numsamples
- Number of input samples at 2MHz sample rate.
- Numsamplescoeff
- Parameter used in TPM, provided by software.
- Pcnf0
- Packet configuration register 0.
- Pcnf1
- Packet configuration register 1.
- Pct16
- Mean magnitude and mean phase converted to IQ.
- Pdustat
- Payload status.
- Phaseshift
- Parameter used in TPM, provided by software.
- Phyendtxdelay
- Configurable delay of PHYEND event for TX.
- Prefix0
- Prefixes bytes for logical addresses 0-3.
- Prefix1
- Prefixes bytes for logical addresses 4-7.
- RadioMode
- Data rate and modulation.
- Rssisample
- RSSI sample.
- RttConfig
- RTT Config.
- Rxaddresses
- Receive address select.
- Rxcrc
- CRC field of previously received packet.
- RxgainConfig
- Override configuration of receiver gain control loop.
- Rxmatch
- Received address.
- Sfd
- IEEE 802.15.4 start of frame delimiter.
- Shorts
- Shortcuts between local events and tasks.
- State
- Current radio state.
- Switchpattern
- GPIO patterns to be used for each antenna.
- Tifs
- Interframe spacing in us.
- Timing
- Timing.
- Txaddress
- Transmit address select.
- Txpower
- Output power.