Module regs
Source - ClkAdcCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkAdcDiv
- ClkAdcSelected
- Indicates which src is currently selected (one-hot)
- ClkGpout0selected
- Indicates which src is currently selected (one-hot)
- ClkGpout1selected
- Indicates which src is currently selected (one-hot)
- ClkGpout2selected
- Indicates which src is currently selected (one-hot)
- ClkGpout3selected
- Indicates which src is currently selected (one-hot)
- ClkGpoutCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkGpoutDiv
- ClkHstxCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkHstxDiv
- ClkHstxSelected
- Indicates which src is currently selected (one-hot)
- ClkPeriCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkPeriDiv
- ClkPeriSelected
- Indicates which src is currently selected (one-hot)
- ClkRefCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkRefDiv
- ClkRefSelected
- Indicates which src is currently selected (one-hot)
- ClkSysCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkSysDiv
- ClkSysResusCtrl
- ClkSysResusStatus
- ClkSysSelected
- Indicates which src is currently selected (one-hot)
- ClkUsbCtrl
- Clock control, can be changed on-the-fly (except for auxsrc)
- ClkUsbDiv
- ClkUsbSelected
- Indicates which src is currently selected (one-hot)
- DftclkLposcCtrl
- DftclkRoscCtrl
- DftclkXoscCtrl
- Enabled0
- indicates the state of the clock enable
- Enabled1
- indicates the state of the clock enable
- Fc0delay
- Delays the start of frequency counting to allow the mux to settle Delay is measured in multiples of the reference clock period
- Fc0interval
- The test interval is 0.98us * 2interval, but let’s call it 1us * 2interval The default gives a test interval of 250us
- Fc0maxKhz
- Maximum pass frequency in kHz. This is optional. Set to 0x1ffffff if you are not using the pass/fail flags
- Fc0minKhz
- Minimum pass frequency in kHz. This is optional. Set to 0 if you are not using the pass/fail flags
- Fc0refKhz
- Reference clock frequency in kHz
- Fc0result
- Result of frequency measurement, only valid when status_done=1
- Fc0src
- Clock sent to frequency counter, set to 0 when not required Writing to this register initiates the frequency count
- Fc0status
- Frequency counter status
- Int
- Interrupt Enable
- SleepEn0
- enable clock in sleep mode
- SleepEn1
- enable clock in sleep mode
- WakeEn0
- enable clock in wake mode
- WakeEn1
- enable clock in wake mode