Struct Control

pub struct Control<'a> { /* private fields */ }

Control driver.

Implementations

impl<'a> Control<'a>

pub async fn init(&mut self, clm: &[u8])

Initialize WiFi controller.

pub async fn set_power_management(&mut self, mode: PowerManagementMode)

Set power management mode.

pub async fn join( &mut self, ssid: &str, options: JoinOptions<'_>, ) -> Result<(), Error>

Join an unprotected network with the provided ssid.

pub async fn gpio_set(&mut self, gpio_n: u8, gpio_en: bool)

Set GPIO pin on WiFi chip.

pub async fn start_ap_open(&mut self, ssid: &str, channel: u8)

Start open access point.

pub async fn start_ap_wpa2(&mut self, ssid: &str, passphrase: &str, channel: u8)

Start WPA2 protected access point.

pub async fn close_ap(&mut self)

Closes access point.

pub async fn add_multicast_address( &mut self, address: [u8; 6], ) -> Result<usize, AddMulticastAddressError>

Add specified address to the list of hardware addresses the device listens on. The address must be a Group address (I/G bit set). Up to 10 addresses are supported by the firmware. Returns the number of address slots filled after adding, or an error.

pub async fn list_mulistcast_addresses( &mut self, result: &mut [[u8; 6]; 10], ) -> usize

Retrieve the list of configured multicast hardware addresses.

pub async fn scan(&mut self, scan_opts: ScanOptions) -> Scanner<'_>

Start a wifi scan

Returns a Stream of networks found by the device

Note

Device events are currently implemented using a bounded queue. To not miss any events, you should make sure to always await the stream.

pub async fn leave(&mut self)

Leave the wifi, with which we are currently associated.

pub async fn address(&mut self) -> [u8; 6]

Gets the MAC address of the device