Module regs
- AuxdatadmaAmount
- Description cluster: Number of 32-bit words transferred in the last transaction
- AuxdatadmaMaxcnt
- Description cluster: Maximum number of 32-bit words to transfer
- Ccactrl
- IEEE 802.15.4 clear channel assessment control
- CfoStat
- Carrier freq. offset estimate
- Clearpattern
- Clear the GPIO pattern array for antenna control
- Cnf
- Description collection: AUXDATA configuration
- Crccnf
- CRC configuration
- Crcinit
- CRC initial value
- Crcpoly
- CRC polynomial
- Crcstatus
- CRC status
- CstonesMode
- Selects the mode(s) that are activated on the start signal
- Cteinlineconf
- Configuration for CTE inline mode
- Ctestatus
- CTEInfo parsed from received packet
- Currentamount
- Number of bytes transferred in the current transaction
- Dacnf
- Device address match configuration
- Dai
- Device address match index
- Dap
- Description collection: Device address prefix n
- Datawhite
- Data whitening configuration
- Dbccorr
- Correlator thresholds
- Dfectrl1
- Various configuration for Direction finding
- Dfectrl2
- Start offset for Direction finding
- Dfemode
- Whether to use Angle-of-Arrival (AOA) or Angle-of-Departure (AOD)
- DfepacketAmount
- Number of bytes transferred in the last transaction
- DfepacketMaxcnt
- Maximum number of bytes to transfer
- Dfestatus
- DFE status information
- Downsample
- Turn on/off down sample of input IQ-signals
- Edctrl
- IEEE 802.15.4 energy detect control
- Edsample
- IEEE 802.15.4 energy detect level
- Enable
- Description cluster: Enable or disable data acquisition
- Faepeer
- FAEPEER (Frequency Actuation Error) of peer if known. Used during Mode 0 steps.
- Feconfig
- Config register
- Ffoest
- FFO estimate
- Freqfinetune
- Fine tuning of the RF frequency
- Freqoffset
- Frequency offset estimate
- Frequency
- Frequency
- Int0
- Disable interrupt
- Int1
- Disable interrupt
- Iqrawmean
- Mean of IQ values
- Magphasemean
- Mean magnitude and phase of the signal before it is converted to PCT16
- Magstd
- Magnitude standard deviation approximation
- Nextfrequency
- The value of FREQUENCY that will be used in the next step
- Numsamples
- Number of input samples at 2MHz sample rate
- Numsamplescoeff
- Parameter used in TPM, provided by software
- Pcnf0
- Packet configuration register 0
- Pcnf1
- Packet configuration register 1
- Pct16
- Mean magnitude and mean phase converted to IQ
- Pdustat
- Payload status
- Phaseshift
- Parameter used in TPM, provided by software
- Phyendtxdelay
- Configurable delay of PHYEND event for TX
- Prefix0
- Prefixes bytes for logical addresses 0-3
- Prefix1
- Prefixes bytes for logical addresses 4-7
- RadioMode
- Data rate and modulation
- Rssisample
- RSSI sample
- RttConfig
- RTT Config.
- Rxaddresses
- Receive address select
- Rxcrc
- CRC field of previously received packet
- RxgainConfig
- Override configuration of receiver gain control loop
- Rxmatch
- Received address
- Sfd
- IEEE 802.15.4 start of frame delimiter
- Shorts
- Shortcuts between local events and tasks
- State
- Current radio state
- Switchpattern
- GPIO patterns to be used for each antenna
- Tifs
- Interframe spacing in us
- Timing
- Timing
- Txaddress
- Transmit address select
- Txpower
- Output power