Struct nrf_softdevice_mbr::sd_mbr_command_copy_bl_t

#[repr(C)]
pub struct sd_mbr_command_copy_bl_t {
    pub bl_src: *mut u32,
    pub bl_len: u32,
}

@brief This command copies a new BootLoader.

The MBR assumes that either @ref MBR_BOOTLOADER_ADDR or @ref MBR_UICR_BOOTLOADER_ADDR is set to the address where the bootloader will be copied. If both addresses are set, the MBR will prioritize @ref MBR_BOOTLOADER_ADDR.

The bootloader destination is erased by this function. If (destination+bl_len) is in the middle of a flash page, that whole flash page will be erased.

This command requires that @ref MBR_PARAM_PAGE_ADDR or @ref MBR_UICR_PARAM_PAGE_ADDR is set, see @ref sd_mbr_command.

This command will use the flash protect peripheral (BPROT or ACL) to protect the flash that is not intended to be written.

On success, this function will not return. It will start the new bootloader from reset-vector as normal.

@retval ::NRF_ERROR_INTERNAL indicates an internal error that should not happen. @retval ::NRF_ERROR_FORBIDDEN if the bootloader address is not set. @retval ::NRF_ERROR_INVALID_LENGTH if parameters attempts to read or write outside flash area. @retval ::NRF_ERROR_NO_MEM No MBR parameter page is provided. See @ref sd_mbr_command.

Fields

bl_src: *mut u32

< Pointer to the source of the bootloader to be be copied.

bl_len: u32

< Number of 32 bit words to copy for BootLoader.

Trait Implementations

impl Clone for sd_mbr_command_copy_bl_t

fn clone(&self) -> sd_mbr_command_copy_bl_t

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for sd_mbr_command_copy_bl_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Copy for sd_mbr_command_copy_bl_t