Struct nrf_softdevice_s113::ble_common_opt_pa_lna_t

#[repr(C)]
pub struct ble_common_opt_pa_lna_t {
    pub pa_cfg: ble_pa_lna_cfg_t,
    pub lna_cfg: ble_pa_lna_cfg_t,
    pub ppi_ch_id_set: u8,
    pub ppi_ch_id_clr: u8,
    pub gpiote_ch_id: u8,
}

@brief PA & LNA GPIO toggle configuration

This option configures the SoftDevice to toggle pins when the radio is active for use with a power amplifier and/or a low noise amplifier.

Toggling the pins is achieved by using two PPI channels and a GPIOTE channel. The hardware channel IDs are provided by the application and should be regarded as reserved as long as any PA/LNA toggling is enabled.

@note @ref sd_ble_opt_get is not supported for this option. @note Setting this option while the radio is in use (i.e. any of the roles are active) may have undefined consequences and must be avoided by the application.

Fields

pa_cfg: ble_pa_lna_cfg_t

< Power Amplifier configuration

lna_cfg: ble_pa_lna_cfg_t

< Low Noise Amplifier configuration

ppi_ch_id_set: u8

< PPI channel used for radio pin setting

ppi_ch_id_clr: u8

< PPI channel used for radio pin clearing

gpiote_ch_id: u8

< GPIOTE channel used for radio pin toggling

Trait Implementations

impl Clone for ble_common_opt_pa_lna_t

fn clone(&self) -> ble_common_opt_pa_lna_t

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ble_common_opt_pa_lna_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Copy for ble_common_opt_pa_lna_t