Struct nrf_softdevice_s132::sd_mbr_command_vector_table_base_set_t

#[repr(C)]
pub struct sd_mbr_command_vector_table_base_set_t {
    pub address: u32,
}

@brief Change the address the MBR starts after a reset

Once this function has been called, this address is where the MBR will start to forward interrupts to after a reset.

To restore default forwarding, this function should be called with @ref address set to 0. If a bootloader is present, interrupts will be forwarded to the bootloader. If not, interrupts will be forwarded to the SoftDevice.

The location of a bootloader can be specified in @ref MBR_BOOTLOADER_ADDR or @ref MBR_UICR_BOOTLOADER_ADDR. If both addresses are set, the MBR will prioritize @ref MBR_BOOTLOADER_ADDR.

This command requires that @ref MBR_PARAM_PAGE_ADDR or @ref MBR_UICR_PARAM_PAGE_ADDR is set, see @ref sd_mbr_command.

On success, this function will not return. It will reset the device.

@retval ::NRF_ERROR_INTERNAL indicates an internal error that should not happen. @retval ::NRF_ERROR_INVALID_ADDR if parameter address is outside of the flash size. @retval ::NRF_ERROR_NO_MEM No MBR parameter page is provided. See @ref sd_mbr_command.

Fields

address: u32

< The base address of the interrupt vector table for forwarded interrupts.

Trait Implementations

impl Clone for sd_mbr_command_vector_table_base_set_t

fn clone(&self) -> sd_mbr_command_vector_table_base_set_t

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for sd_mbr_command_vector_table_base_set_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Copy for sd_mbr_command_vector_table_base_set_t