Struct rp_pac::i2c::regs::IcCompParam1

#[repr(transparent)]
pub struct IcCompParam1(pub u32);

Component Parameter Register 1 Note This register is not implemented and therefore reads as 0. If it was implemented it would be a constant read-only register that contains encoded information about the component’s parameter settings. Fields shown below are the settings for those parameters

Tuple Fields

0: u32

Implementations

impl IcCompParam1

pub const fn apb_data_width(&self) -> u8

APB data bus width is 32 bits

pub fn set_apb_data_width(&mut self, val: u8)

APB data bus width is 32 bits

pub const fn max_speed_mode(&self) -> u8

MAX SPEED MODE = FAST MODE

pub fn set_max_speed_mode(&mut self, val: u8)

MAX SPEED MODE = FAST MODE

pub const fn hc_count_values(&self) -> bool

Programmable count values for each mode.

pub fn set_hc_count_values(&mut self, val: bool)

Programmable count values for each mode.

pub const fn intr_io(&self) -> bool

COMBINED Interrupt outputs

pub fn set_intr_io(&mut self, val: bool)

COMBINED Interrupt outputs

pub const fn has_dma(&self) -> bool

DMA handshaking signals are enabled

pub fn set_has_dma(&mut self, val: bool)

DMA handshaking signals are enabled

pub const fn add_encoded_params(&self) -> bool

Encoded parameters not visible

pub fn set_add_encoded_params(&mut self, val: bool)

Encoded parameters not visible

pub const fn rx_buffer_depth(&self) -> u8

RX Buffer Depth = 16

pub fn set_rx_buffer_depth(&mut self, val: u8)

RX Buffer Depth = 16

pub const fn tx_buffer_depth(&self) -> u8

TX Buffer Depth = 16

pub fn set_tx_buffer_depth(&mut self, val: u8)

TX Buffer Depth = 16

Trait Implementations

impl Clone for IcCompParam1

fn clone(&self) -> IcCompParam1

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for IcCompParam1

fn default() -> IcCompParam1

Returns the “default value” for a type.

impl PartialEq<IcCompParam1> for IcCompParam1

fn eq(&self, other: &IcCompParam1) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for IcCompParam1

impl Eq for IcCompParam1

impl StructuralEq for IcCompParam1

impl StructuralPartialEq for IcCompParam1