Struct rp_pac::i2c::regs::IcFsSclHcnt

#[repr(transparent)]
pub struct IcFsSclHcnt(pub u32);

Fast Mode or Fast Mode Plus I2C Clock SCL High Count Register

Tuple Fields

0: u32

Implementations

impl IcFsSclHcnt

pub const fn ic_fs_scl_hcnt(&self) -> u16

This register must be set before any I2C bus transaction can take place to ensure proper I/O timing. This register sets the SCL clock high-period count for fast mode or fast mode plus. It is used in high-speed mode to send the Master Code and START BYTE or General CALL. For more information, refer to ‘IC_CLK Frequency Configuration’. This register goes away and becomes read-only returning 0s if IC_MAX_SPEED_MODE = standard. This register can be written only when the I2C interface is disabled, which corresponds to the IC_ENABLE[0] register being set to 0. Writes at other times have no effect. The minimum valid value is 6; hardware prevents values less than this being written, and if attempted results in 6 being set. For designs with APB_DATA_WIDTH == 8 the order of programming is important to ensure the correct operation of the DW_apb_i2c. The lower byte must be programmed first. Then the upper byte is programmed.

pub fn set_ic_fs_scl_hcnt(&mut self, val: u16)

This register must be set before any I2C bus transaction can take place to ensure proper I/O timing. This register sets the SCL clock high-period count for fast mode or fast mode plus. It is used in high-speed mode to send the Master Code and START BYTE or General CALL. For more information, refer to ‘IC_CLK Frequency Configuration’. This register goes away and becomes read-only returning 0s if IC_MAX_SPEED_MODE = standard. This register can be written only when the I2C interface is disabled, which corresponds to the IC_ENABLE[0] register being set to 0. Writes at other times have no effect. The minimum valid value is 6; hardware prevents values less than this being written, and if attempted results in 6 being set. For designs with APB_DATA_WIDTH == 8 the order of programming is important to ensure the correct operation of the DW_apb_i2c. The lower byte must be programmed first. Then the upper byte is programmed.

Trait Implementations

impl Clone for IcFsSclHcnt

fn clone(&self) -> IcFsSclHcnt

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for IcFsSclHcnt

fn default() -> IcFsSclHcnt

Returns the “default value” for a type.

impl PartialEq<IcFsSclHcnt> for IcFsSclHcnt

fn eq(&self, other: &IcFsSclHcnt) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for IcFsSclHcnt

impl Eq for IcFsSclHcnt

impl StructuralEq for IcFsSclHcnt

impl StructuralPartialEq for IcFsSclHcnt