Struct rp_pac::i2c::regs::IcSdaHold

#[repr(transparent)]
pub struct IcSdaHold(pub u32);

I2C SDA Hold Time Length Register The bits [15:0] of this register are used to control the hold time of SDA during transmit in both slave and master mode (after SCL goes from HIGH to LOW). The bits [23:16] of this register are used to extend the SDA transition (if any) whenever SCL is HIGH in the receiver in either master or slave mode. Writes to this register succeed only when IC_ENABLE[0]=0. The values in this register are in units of ic_clk period. The value programmed in IC_SDA_TX_HOLD must be greater than the minimum hold time in each mode (one cycle in master mode, seven cycles in slave mode) for the value to be implemented. The programmed SDA hold time during transmit (IC_SDA_TX_HOLD) cannot exceed at any time the duration of the low part of scl. Therefore the programmed value cannot be larger than N_SCL_LOW-2, where N_SCL_LOW is the duration of the low part of the scl period measured in ic_clk cycles.

Tuple Fields

0: u32

Implementations

impl IcSdaHold

pub const fn ic_sda_tx_hold(&self) -> u16

Sets the required SDA hold time in units of ic_clk period, when DW_apb_i2c acts as a transmitter. Reset value: IC_DEFAULT_SDA_HOLD[15:0].

pub fn set_ic_sda_tx_hold(&mut self, val: u16)

Sets the required SDA hold time in units of ic_clk period, when DW_apb_i2c acts as a transmitter. Reset value: IC_DEFAULT_SDA_HOLD[15:0].

pub const fn ic_sda_rx_hold(&self) -> u8

Sets the required SDA hold time in units of ic_clk period, when DW_apb_i2c acts as a receiver. Reset value: IC_DEFAULT_SDA_HOLD[23:16].

pub fn set_ic_sda_rx_hold(&mut self, val: u8)

Sets the required SDA hold time in units of ic_clk period, when DW_apb_i2c acts as a receiver. Reset value: IC_DEFAULT_SDA_HOLD[23:16].

Trait Implementations

impl Clone for IcSdaHold

fn clone(&self) -> IcSdaHold

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for IcSdaHold

fn default() -> IcSdaHold

Returns the “default value” for a type.

impl PartialEq<IcSdaHold> for IcSdaHold

fn eq(&self, other: &IcSdaHold) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for IcSdaHold

impl Eq for IcSdaHold

impl StructuralEq for IcSdaHold

impl StructuralPartialEq for IcSdaHold