Struct rp_pac::syscfg::Syscfg

pub struct Syscfg { /* private fields */ }

Register block for various chip control signals

Implementations

impl Syscfg

pub const unsafe fn from_ptr(ptr: *mut ()) -> Self

pub const fn as_ptr(&self) -> *mut ()

pub const fn proc0_nmi_mask(self) -> Reg<u32, RW>

Processor core 0 NMI source mask Set a bit high to enable NMI from that IRQ

pub const fn proc1_nmi_mask(self) -> Reg<u32, RW>

Processor core 1 NMI source mask Set a bit high to enable NMI from that IRQ

pub const fn proc_config(self) -> Reg<ProcConfig, RW>

Configuration for processors

pub const fn proc_in_sync_bypass(self) -> Reg<ProcInSyncBypass, RW>

For each bit, if 1, bypass the input synchronizer between that GPIO and the GPIO input register in the SIO. The input synchronizers should generally be unbypassed, to avoid injecting metastabilities into processors. If you’re feeling brave, you can bypass to save two cycles of input latency. This register applies to GPIO 0…29.

pub const fn proc_in_sync_bypass_hi(self) -> Reg<ProcInSyncBypassHi, RW>

For each bit, if 1, bypass the input synchronizer between that GPIO and the GPIO input register in the SIO. The input synchronizers should generally be unbypassed, to avoid injecting metastabilities into processors. If you’re feeling brave, you can bypass to save two cycles of input latency. This register applies to GPIO 30…35 (the QSPI IOs).

pub const fn dbgforce(self) -> Reg<Dbgforce, RW>

Directly control the SWD debug port of either processor

pub const fn mempowerdown(self) -> Reg<Mempowerdown, RW>

Control power downs to memories. Set high to power down memories. Use with extreme caution

Trait Implementations

impl Clone for Syscfg

fn clone(&self) -> Syscfg

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl PartialEq<Syscfg> for Syscfg

fn eq(&self, other: &Syscfg) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Syscfg

impl Eq for Syscfg

impl Send for Syscfg

impl StructuralEq for Syscfg

impl StructuralPartialEq for Syscfg

impl Sync for Syscfg