Struct stm32_metapac::vrefbuf::regs::Ccr

#[repr(transparent)]
pub struct Ccr(pub u32);

VREFBUF calibration control register.

Tuple Fields

0: u32

Implementations

impl Ccr

pub const fn trim(&self) -> u8

Trimming code The TRIM code is a 6-bit unsigned data (minimum 000000, maximum 111111) that is set and updated according the mechanism described below. Reset: TRIM[5:0] is automatically initialized with the VRS = 0 trimming value stored in the Flash memory during the production test. VRS change: TRIM[5:0] is automatically initialized with the trimming value (corresponding to VRS setting) stored in the Flash memory during the production test. Write in TRIM[5:0]: User can modify the TRIM[5:0] with an arbitrary value. This is permanently disabling the control of the trimming value with VRS (until the device is reset). Note: If the user application performs the trimming, the trimming code must start from 000000 to 111111 in ascending order.

pub fn set_trim(&mut self, val: u8)

Trimming code The TRIM code is a 6-bit unsigned data (minimum 000000, maximum 111111) that is set and updated according the mechanism described below. Reset: TRIM[5:0] is automatically initialized with the VRS = 0 trimming value stored in the Flash memory during the production test. VRS change: TRIM[5:0] is automatically initialized with the trimming value (corresponding to VRS setting) stored in the Flash memory during the production test. Write in TRIM[5:0]: User can modify the TRIM[5:0] with an arbitrary value. This is permanently disabling the control of the trimming value with VRS (until the device is reset). Note: If the user application performs the trimming, the trimming code must start from 000000 to 111111 in ascending order.

Trait Implementations

impl Clone for Ccr

fn clone(&self) -> Ccr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Ccr

fn default() -> Ccr

Returns the “default value” for a type.

impl PartialEq for Ccr

fn eq(&self, other: &Ccr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Ccr

impl Eq for Ccr

impl StructuralPartialEq for Ccr