Struct stm32_metapac::dmamux::regs::Ccr

#[repr(transparent)]
pub struct Ccr(pub u32);

DMAMux - DMA request line multiplexer channel x control register

Tuple Fields

0: u32

Implementations

impl Ccr

pub const fn dmareq_id(&self) -> u8

Input DMA request line selected

pub fn set_dmareq_id(&mut self, val: u8)

Input DMA request line selected

pub const fn soie(&self) -> bool

Interrupt enable at synchronization event overrun

pub fn set_soie(&mut self, val: bool)

Interrupt enable at synchronization event overrun

pub const fn ege(&self) -> bool

Event generation enable/disable

pub fn set_ege(&mut self, val: bool)

Event generation enable/disable

pub const fn se(&self) -> bool

Synchronous operating mode enable/disable

pub fn set_se(&mut self, val: bool)

Synchronous operating mode enable/disable

pub const fn spol(&self) -> Pol

Synchronization event type selector Defines the synchronization event on the selected synchronization input:

pub fn set_spol(&mut self, val: Pol)

Synchronization event type selector Defines the synchronization event on the selected synchronization input:

pub const fn nbreq(&self) -> u8

Number of DMA requests to forward Defines the number of DMA requests forwarded before output event is generated. In synchronous mode, it also defines the number of DMA requests to forward after a synchronization event, then stop forwarding. The actual number of DMA requests forwarded is NBREQ+1. Note: This field can only be written when both SE and EGE bits are reset.

pub fn set_nbreq(&mut self, val: u8)

Number of DMA requests to forward Defines the number of DMA requests forwarded before output event is generated. In synchronous mode, it also defines the number of DMA requests to forward after a synchronization event, then stop forwarding. The actual number of DMA requests forwarded is NBREQ+1. Note: This field can only be written when both SE and EGE bits are reset.

pub const fn sync_id(&self) -> u8

Synchronization input selected

pub fn set_sync_id(&mut self, val: u8)

Synchronization input selected

Trait Implementations

impl Clone for Ccr

fn clone(&self) -> Ccr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Ccr

fn default() -> Ccr

Returns the “default value” for a type.

impl PartialEq for Ccr

fn eq(&self, other: &Ccr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Ccr

impl Eq for Ccr

impl StructuralPartialEq for Ccr