Struct stm32_metapac::vrefbuf::regs::Csr

#[repr(transparent)]
pub struct Csr(pub u32);

VREFBUF control and status register.

Tuple Fields

0: u32

Implementations

impl Csr

pub const fn envr(&self) -> bool

Voltage reference buffer mode enable This bit is used to enable the voltage reference buffer mode.

pub fn set_envr(&mut self, val: bool)

Voltage reference buffer mode enable This bit is used to enable the voltage reference buffer mode.

pub const fn hiz(&self) -> Hiz

High impedance mode This bit controls the analog switch to connect or not the VREF+ pin. Refer to for the mode descriptions depending on ENVR bit configuration.

pub fn set_hiz(&mut self, val: Hiz)

High impedance mode This bit controls the analog switch to connect or not the VREF+ pin. Refer to for the mode descriptions depending on ENVR bit configuration.

pub const fn vrr(&self) -> bool

Voltage reference buffer ready.

pub fn set_vrr(&mut self, val: bool)

Voltage reference buffer ready.

pub const fn vrs(&self) -> Vrs

Voltage reference scale These bits select the value generated by the voltage reference buffer. VRS = 000: VREFBUF0 voltage selected. VRS = 001: VREFBUF1 voltage selected. VRS = 010: VREFBUF2 voltage selected. VRS = 011: VREFBUF3 voltage selected. Others: Reserved Note: Refer to the product datasheet for each VREFBUFx voltage setting value. The software can program this bitfield only when the VREFBUF is disabled (ENVR=0).

pub fn set_vrs(&mut self, val: Vrs)

Voltage reference scale These bits select the value generated by the voltage reference buffer. VRS = 000: VREFBUF0 voltage selected. VRS = 001: VREFBUF1 voltage selected. VRS = 010: VREFBUF2 voltage selected. VRS = 011: VREFBUF3 voltage selected. Others: Reserved Note: Refer to the product datasheet for each VREFBUFx voltage setting value. The software can program this bitfield only when the VREFBUF is disabled (ENVR=0).

Trait Implementations

impl Clone for Csr

fn clone(&self) -> Csr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Csr

fn default() -> Csr

Returns the “default value” for a type.

impl PartialEq for Csr

fn eq(&self, other: &Csr) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Csr

impl Eq for Csr

impl StructuralEq for Csr

impl StructuralPartialEq for Csr