Struct stm32_metapac::pwr::regs::Cr2

#[repr(transparent)]
pub struct Cr2(pub u32);

Power control register 2

Tuple Fields

0: u32

Implementations

impl Cr2

pub const fn pvde(&self) -> bool

Programmable voltage detector enable Note: This bit is write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: This bit is reset only by a system reset.

pub fn set_pvde(&mut self, val: bool)

Programmable voltage detector enable Note: This bit is write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: This bit is reset only by a system reset.

pub const fn pls(&self) -> Pls

Programmable voltage detector level selection. These bits select the voltage threshold detected by the programmable voltage detector: Note: These bits are write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: These bits are reset only by a system reset.

pub fn set_pls(&mut self, val: Pls)

Programmable voltage detector level selection. These bits select the voltage threshold detected by the programmable voltage detector: Note: These bits are write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: These bits are reset only by a system reset.

pub const fn pvme1(&self) -> bool

Peripheral voltage monitoring 1 enable: V_DDUSB vs. 1.21V

pub fn set_pvme1(&mut self, val: bool)

Peripheral voltage monitoring 1 enable: V_DDUSB vs. 1.21V

pub const fn pvme3(&self) -> bool

Peripheral voltage monitoring 3 enable: V_DDA vs. 1.621V

pub fn set_pvme3(&mut self, val: bool)

Peripheral voltage monitoring 3 enable: V_DDA vs. 1.621V

pub const fn pvme4(&self) -> bool

Peripheral voltage monitoring 4 enable: V_DDA vs. 1.861V

pub fn set_pvme4(&mut self, val: bool)

Peripheral voltage monitoring 4 enable: V_DDA vs. 1.861V

pub const fn usv(&self) -> bool

V_DDUSB USB supply valid This bit is used to validate the V_DDUSB supply for electrical and logical isolation purpose. Setting this bit is mandatory to use the USB FS peripheral. If V_DDUSB is not always present in the application, the PVM can be used to determine whether this supply is ready or not.

pub fn set_usv(&mut self, val: bool)

V_DDUSB USB supply valid This bit is used to validate the V_DDUSB supply for electrical and logical isolation purpose. Setting this bit is mandatory to use the USB FS peripheral. If V_DDUSB is not always present in the application, the PVM can be used to determine whether this supply is ready or not.

Trait Implementations

impl Clone for Cr2

fn clone(&self) -> Cr2

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Cr2

fn default() -> Cr2

Returns the “default value” for a type.

impl PartialEq for Cr2

fn eq(&self, other: &Cr2) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Cr2

impl Eq for Cr2

impl StructuralEq for Cr2

impl StructuralPartialEq for Cr2