Struct stm32_metapac::flash::regs::Secbootadd0r

#[repr(transparent)]
pub struct Secbootadd0r(pub u32);

FLASH secure boot address 0 register

Tuple Fields

0: u32

Implementations

impl Secbootadd0r

pub const fn boot_lock(&self) -> bool

Boot lock When set, the boot is always forced to base address value programmed in SECBOOTADD0[24:0] option bytes whatever the boot selection option. When set, this bit can only be cleared by an RDP at level 0.

pub fn set_boot_lock(&mut self, val: bool)

Boot lock When set, the boot is always forced to base address value programmed in SECBOOTADD0[24:0] option bytes whatever the boot selection option. When set, this bit can only be cleared by an RDP at level 0.

pub const fn secbootadd0(&self) -> u32

Secure boot base address 0 The secure boot memory address can be programmed to any address in the valid address range with a granularity of 128 bytes. This bits correspond to address [31:7] The SECBOOTADD0 option bytes are selected following the BOOT0 pin or nSWBOOT0 state. Examples: SECBOOTADD0[24:0] = 0x018 0000: Boot from secure Flash memory (0x0C00 0000) SECBOOTADD0[24:0] = 0x01F F000: Boot from RSS (0x0FF8 0000) SECBOOTADD0[24:0] = 0x060 0000: Boot from secure SRAM1 on S-Bus (0x3000 0000)

pub fn set_secbootadd0(&mut self, val: u32)

Secure boot base address 0 The secure boot memory address can be programmed to any address in the valid address range with a granularity of 128 bytes. This bits correspond to address [31:7] The SECBOOTADD0 option bytes are selected following the BOOT0 pin or nSWBOOT0 state. Examples: SECBOOTADD0[24:0] = 0x018 0000: Boot from secure Flash memory (0x0C00 0000) SECBOOTADD0[24:0] = 0x01F F000: Boot from RSS (0x0FF8 0000) SECBOOTADD0[24:0] = 0x060 0000: Boot from secure SRAM1 on S-Bus (0x3000 0000)

Trait Implementations

impl Clone for Secbootadd0r

fn clone(&self) -> Secbootadd0r

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Secbootadd0r

fn default() -> Secbootadd0r

Returns the “default value” for a type.

impl PartialEq for Secbootadd0r

fn eq(&self, other: &Secbootadd0r) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Secbootadd0r

impl Eq for Secbootadd0r

impl StructuralEq for Secbootadd0r

impl StructuralPartialEq for Secbootadd0r