Struct CcRng

pub struct CcRng { /* private fields */ }

CRYPTOCELL RNG engine

Implementations

impl CcRng

pub const unsafe fn from_ptr(ptr: *mut ()) -> Self

pub const fn as_ptr(&self) -> *mut ()

pub const fn rng_imr(self) -> Reg<RngImr, RW>

Interrupt mask register. Each bit of this register holds the mask of a single interrupt source.

pub const fn rng_isr(self) -> Reg<RngIsr, R>

Interrupt status register. Each bit of this register holds the interrupt status of a single interrupt source. If corresponding RNG_IMR bit is unmasked, an interrupt is generated.

pub const fn rng_icr(self) -> Reg<RngIcr, W>

Interrupt clear register. Writing a 1 bit into a field in this register will clear the corresponding bit in RNG_ISR.

pub const fn trng_config(self) -> Reg<TrngConfig, RW>

TRNG ring oscillator length configuration

pub const fn trng_valid(self) -> Reg<TrngValid, R>

This register indicates if TRNG entropy collection is valid.

pub const fn ehr_data(self, n: usize) -> Reg<u32, R>

Description collection: The entropy holding registers (EHR) hold 192-bits random data collected by the TRNG. The initial EHR_DATA[0] register holds the least significant bits [31:0] of the random data value.

pub const fn noise_source(self) -> Reg<NoiseSource, RW>

This register controls the ring oscillator circuit used as a noise source.

pub const fn sample_cnt(self) -> Reg<u32, RW>

Sample count defining the number of CPU clock cycles between two consecutive noise source samples.

pub const fn autocorr_statistic(self) -> Reg<AutocorrStatistic, RW>

Statistics counter for autocorrelation test activations. Statistics collection is stopped if one of the counters reach its limit of all ones.

pub const fn trng_debug(self) -> Reg<TrngDebug, RW>

Debug register for the TRNG. This register is used to bypass TRNG tests in hardware.

pub const fn rng_sw_reset(self) -> Reg<RngSwReset, W>

Reset the RNG engine.

pub const fn rng_busy(self) -> Reg<RngBusy, R>

Status register for RNG engine activity.

pub const fn trng_reset(self) -> Reg<TrngReset, W>

Reset the TRNG, including internal counter of collected bits and registers EHR_DATA and TRNG_VALID.

pub const fn rng_hw_flags(self) -> Reg<RngHwFlags, R>

Hardware configuration of RNG engine. Reset value holds the supported features.

pub const fn rng_clk(self) -> Reg<RngClk, W>

Control clock for the RNG engine.

pub const fn rng_dma(self) -> Reg<RngDma, RW>

Writing to this register enables the RNG DMA engine.

pub const fn rng_dma_rosc_len(self) -> Reg<RngDmaRoscLen, RW>

This register defines which ring oscillator length configuration should be used when using the RNG DMA engine.

pub const fn rng_dma_sram_addr(self) -> Reg<RngDmaSramAddr, RW>

This register defines the start address in TRNG SRAM for the TRNG data to be collected by the RNG DMA engine.

pub const fn rng_dma_samples_num(self) -> Reg<RngDmaSamplesNum, RW>

This register defines the number of 192-bits samples that the RNG DMA engine collects per run.

pub const fn rng_watchdog_val(self) -> Reg<u32, RW>

This register defines the maximum number of CPU clock cycles per TRNG collection of 192-bits samples. If the number of cycles for a collection exceeds this threshold the WATCHDOG interrupt is triggered.

pub const fn rng_dma_busy(self) -> Reg<RngDmaBusy, R>

Status register for RNG DMA engine activity.

Trait Implementations

impl Clone for CcRng

fn clone(&self) -> CcRng

Returns a duplicate of the value.

const fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl PartialEq for CcRng

fn eq(&self, other: &CcRng) -> bool

Tests for self and other values to be equal, and is used by ==.

const fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for CcRng

impl Eq for CcRng

impl Send for CcRng

impl StructuralPartialEq for CcRng

impl Sync for CcRng