Struct stm32_metapac::adc::regs::Calfact

#[repr(transparent)]
pub struct Calfact(pub u32);

Calibration Factors

Tuple Fields

0: u32

Implementations

impl Calfact

pub const fn calfact_s(&self) -> u8

Calibration Factors In Single-ended mode These bits are written by hardware or by software. Once a single-ended inputs calibration is complete, they are updated by hardware with the calibration factors. Software can write these bits with a new calibration factor. If the new calibration factor is different from the current one stored into the analog ADC, it is then applied once a new single-ended calibration is launched. Note: The software is allowed to write these bits only when ADEN = 1, ADSTART = 0 and JADSTART = 0 (ADC is enabled and no calibration is ongoing and no conversion is ongoing).

pub fn set_calfact_s(&mut self, val: u8)

Calibration Factors In Single-ended mode These bits are written by hardware or by software. Once a single-ended inputs calibration is complete, they are updated by hardware with the calibration factors. Software can write these bits with a new calibration factor. If the new calibration factor is different from the current one stored into the analog ADC, it is then applied once a new single-ended calibration is launched. Note: The software is allowed to write these bits only when ADEN = 1, ADSTART = 0 and JADSTART = 0 (ADC is enabled and no calibration is ongoing and no conversion is ongoing).

pub const fn calfact_d(&self) -> u8

Calibration Factors in differential mode These bits are written by hardware or by software. Once a differential inputs calibration is complete, they are updated by hardware with the calibration factors. Software can write these bits with a new calibration factor. If the new calibration factor is different from the current one stored into the analog ADC, it is then applied once a new differential calibration is launched. Note: The software is allowed to write these bits only when ADEN = 1, ADSTART = 0 and JADSTART = 0 (ADC is enabled and no calibration is ongoing and no conversion is ongoing).

pub fn set_calfact_d(&mut self, val: u8)

Calibration Factors in differential mode These bits are written by hardware or by software. Once a differential inputs calibration is complete, they are updated by hardware with the calibration factors. Software can write these bits with a new calibration factor. If the new calibration factor is different from the current one stored into the analog ADC, it is then applied once a new differential calibration is launched. Note: The software is allowed to write these bits only when ADEN = 1, ADSTART = 0 and JADSTART = 0 (ADC is enabled and no calibration is ongoing and no conversion is ongoing).

Trait Implementations

impl Clone for Calfact

fn clone(&self) -> Calfact

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Calfact

fn default() -> Calfact

Returns the “default value” for a type.

impl PartialEq for Calfact

fn eq(&self, other: &Calfact) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Calfact

impl Eq for Calfact

impl StructuralPartialEq for Calfact