Struct stm32_metapac::rcc::regs::Pllfracr
#[repr(transparent)]pub struct Pllfracr(pub u32);
Expand description
RCC PLL1 fractional divider register
Tuple Fields§
§0: u32
Implementations§
§impl Pllfracr
impl Pllfracr
pub const fn pllfracn(&self) -> u16
pub const fn pllfracn(&self) -> u16
fractional part of the multiplication factor for PLL1 VCO Set and reset by software to control the fractional part of the multiplication factor of the VCO. These bits can be written at any time, allowing dynamic fine-tuning of the PLL1 VCO. The software must set correctly these bits to insure that the VCO output frequency is between its valid frequency range, that is: * 128 to 560 MHz if PLL1VCOSEL = 0 * 150 to 420 MHz if PLL1VCOSEL = 1 VCO output frequency = Fref1_ck x (PLL1N + (PLL1FRACN / 213)), with * PLL1N between 8 and 420 * PLL1FRACN can be between 0 and 213- 1 * The input frequency Fref1_ck must be between 1 and 16 MHz. To change the PLL1FRACN value on-the-fly even if the PLL is enabled, the application must proceed as follows: * Set the bit PLL1FRACEN to 0 * Write the new fractional value into PLL1FRACN * Set the bit PLL1FRACEN to 1
pub fn set_pllfracn(&mut self, val: u16)
pub fn set_pllfracn(&mut self, val: u16)
fractional part of the multiplication factor for PLL1 VCO Set and reset by software to control the fractional part of the multiplication factor of the VCO. These bits can be written at any time, allowing dynamic fine-tuning of the PLL1 VCO. The software must set correctly these bits to insure that the VCO output frequency is between its valid frequency range, that is: * 128 to 560 MHz if PLL1VCOSEL = 0 * 150 to 420 MHz if PLL1VCOSEL = 1 VCO output frequency = Fref1_ck x (PLL1N + (PLL1FRACN / 213)), with * PLL1N between 8 and 420 * PLL1FRACN can be between 0 and 213- 1 * The input frequency Fref1_ck must be between 1 and 16 MHz. To change the PLL1FRACN value on-the-fly even if the PLL is enabled, the application must proceed as follows: * Set the bit PLL1FRACEN to 0 * Write the new fractional value into PLL1FRACN * Set the bit PLL1FRACEN to 1