Struct stm32_metapac::flash::regs::Acr

#[repr(transparent)]
pub struct Acr(pub u32);

FLASH access control register

Tuple Fields

0: u32

Implementations

impl Acr

pub const fn latency(&self) -> u8

Read latency These bits are used to control the number of wait states used during read operations on both nonvolatile memory banks. The application software has to program them to the correct value depending on the embedded flash memory interface frequency and voltage conditions. … Note: No check is performed by hardware to verify that the configuration is correct.

pub fn set_latency(&mut self, val: u8)

Read latency These bits are used to control the number of wait states used during read operations on both nonvolatile memory banks. The application software has to program them to the correct value depending on the embedded flash memory interface frequency and voltage conditions. … Note: No check is performed by hardware to verify that the configuration is correct.

pub const fn wrhighfreq(&self) -> u8

Flash signal delay These bits are used to control the delay between nonvolatile memory signals during programming operations. Application software has to program them to the correct value depending on the embedded flash memory interface frequency. Please refer to Table�44 for details. Note: No check is performed to verify that the configuration is correct. Note: Two WRHIGHFREQ values can be selected for some frequencies.

pub fn set_wrhighfreq(&mut self, val: u8)

Flash signal delay These bits are used to control the delay between nonvolatile memory signals during programming operations. Application software has to program them to the correct value depending on the embedded flash memory interface frequency. Please refer to Table�44 for details. Note: No check is performed to verify that the configuration is correct. Note: Two WRHIGHFREQ values can be selected for some frequencies.

pub const fn prften(&self) -> bool

Prefetch enable. When bit value is modified, user must read back ACR register to be sure PRFTEN has been taken into account. Bits used to control the prefetch.

pub fn set_prften(&mut self, val: bool)

Prefetch enable. When bit value is modified, user must read back ACR register to be sure PRFTEN has been taken into account. Bits used to control the prefetch.

Trait Implementations

impl Clone for Acr

fn clone(&self) -> Acr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Acr

fn default() -> Acr

Returns the “default value” for a type.

impl PartialEq for Acr

fn eq(&self, other: &Acr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Acr

impl Eq for Acr

impl StructuralPartialEq for Acr