Struct stm32_metapac::pwr::regs::Vmsr

#[repr(transparent)]
pub struct Vmsr(pub u32);

PWR voltage monitor status register.

Tuple Fields

0: u32

Implementations

impl Vmsr

pub const fn avdo(&self) -> bool

analog voltage detector output on V_DDA This bit is set and cleared by hardware. It is valid only if AVD on VDDA is enabled by the AVDEN bit. Note: Since the AVD is disabled in Standby mode, this bit is equal to 0 after standby or reset until the AVDEN bit is set.

pub fn set_avdo(&mut self, val: bool)

analog voltage detector output on V_DDA This bit is set and cleared by hardware. It is valid only if AVD on VDDA is enabled by the AVDEN bit. Note: Since the AVD is disabled in Standby mode, this bit is equal to 0 after standby or reset until the AVDEN bit is set.

pub const fn vddio2rdy(&self) -> bool

voltage detector output on V_DDIO2 This bit is set and cleared by hardware.

pub fn set_vddio2rdy(&mut self, val: bool)

voltage detector output on V_DDIO2 This bit is set and cleared by hardware.

pub const fn pvdo(&self) -> bool

programmable voltage detect output This bit is set and cleared by hardware. It is valid only if the PVD has been enabled by the PVDE bit. Note: Since the PVD is disabled in Standby mode, this bit is equal to 0 after Standby or reset until the PVDE bit is set.

pub fn set_pvdo(&mut self, val: bool)

programmable voltage detect output This bit is set and cleared by hardware. It is valid only if the PVD has been enabled by the PVDE bit. Note: Since the PVD is disabled in Standby mode, this bit is equal to 0 after Standby or reset until the PVDE bit is set.

pub const fn usb33rdy(&self) -> bool

V_DDUSB ready.

pub fn set_usb33rdy(&mut self, val: bool)

V_DDUSB ready.

Trait Implementations

impl Clone for Vmsr

fn clone(&self) -> Vmsr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Vmsr

fn default() -> Vmsr

Returns the “default value” for a type.

impl PartialEq for Vmsr

fn eq(&self, other: &Vmsr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Vmsr

impl Eq for Vmsr

impl StructuralPartialEq for Vmsr