Struct stm32_metapac::pwr::regs::Vmsr

#[repr(transparent)]
pub struct Vmsr(pub u32);

PWR voltage monitor status register.

Tuple Fields

0: u32

Implementations

impl Vmsr

pub const fn avdo(&self) -> bool

analog voltage detector output on V_DDA This bit is set and cleared by hardware. It is valid only if AVD on VDDA is enabled by the AVDEN bit. Note: Since the AVD is disabled in Standby mode, this bit is equal to 0 after standby or reset until the AVDEN bit is set.

pub fn set_avdo(&mut self, val: bool)

analog voltage detector output on V_DDA This bit is set and cleared by hardware. It is valid only if AVD on VDDA is enabled by the AVDEN bit. Note: Since the AVD is disabled in Standby mode, this bit is equal to 0 after standby or reset until the AVDEN bit is set.

pub const fn vddio2rdy(&self) -> bool

voltage detector output on V_DDIO2 This bit is set and cleared by hardware.

pub fn set_vddio2rdy(&mut self, val: bool)

voltage detector output on V_DDIO2 This bit is set and cleared by hardware.

pub const fn pvdo(&self) -> bool

programmable voltage detect output This bit is set and cleared by hardware. It is valid only if the PVD has been enabled by the PVDE bit. Note: Since the PVD is disabled in Standby mode, this bit is equal to 0 after Standby or reset until the PVDE bit is set.

pub fn set_pvdo(&mut self, val: bool)

programmable voltage detect output This bit is set and cleared by hardware. It is valid only if the PVD has been enabled by the PVDE bit. Note: Since the PVD is disabled in Standby mode, this bit is equal to 0 after Standby or reset until the PVDE bit is set.

pub const fn usb33rdy(&self) -> bool

V_DDUSB ready.

pub fn set_usb33rdy(&mut self, val: bool)

V_DDUSB ready.

Trait Implementations

impl Clone for Vmsr

fn clone(&self) -> Vmsr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Vmsr

fn default() -> Vmsr

Returns the “default value” for a type.

impl PartialEq for Vmsr

fn eq(&self, other: &Vmsr) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Vmsr

impl Eq for Vmsr

impl StructuralEq for Vmsr

impl StructuralPartialEq for Vmsr