Enum stm32_metapac::i3c::vals::Rstact

#[repr(u8)]
pub enum Rstact {
    NORESET = 0,
    FIRSTLEVEL = 1,
    SECONDLEVEL = 2,
    NORESETEITHER = 3,
}

Variants

NORESET = 0

FIRSTLEVEL = 1

first level of reset: the application software must either: a) partially reset the peripheral, by a write and clear of the enable bit of the I3C configuration register (write EN = 0). This resets the I3C bus interface and the I3C kernel sub-parts, without modifying the content of the I3C APB registers (except the EN bit). b) fully reset the peripheral, including all its registers, via a write and set of the I3C reset control bit of the RCC (reset and clock controller) register.

SECONDLEVEL = 2

second level of reset: the application software must issue a warm reset, also known as a system reset. This (see Section 11: Reset and clock control (RCC)) has the same impact as a pin reset (NRST = 0): – the software writes and sets the SYSRESETREQ control bit of the AITR register, when the device is controlled by a Cortex®-M. – the software writes and sets SYSRST = 1 in the RCC_GRSTCSETR register, when the device is controlled by a Cortex®-A.

NORESETEITHER = 3

Implementations

impl Rstact

pub const fn from_bits(val: u8) -> Rstact

pub const fn to_bits(self) -> u8

Trait Implementations

impl Clone for Rstact

fn clone(&self) -> Rstact

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl From<Rstact> for u8

fn from(val: Rstact) -> u8

Converts to this type from the input type.

impl From<u8> for Rstact

fn from(val: u8) -> Rstact

Converts to this type from the input type.

impl Ord for Rstact

fn cmp(&self, other: &Rstact) -> Ordering

This method returns an Ordering between self and other.

fn max(self, other: Self) -> Self

where Self: Sized,

Compares and returns the maximum of two values.

fn min(self, other: Self) -> Self

where Self: Sized,

Compares and returns the minimum of two values.

fn clamp(self, min: Self, max: Self) -> Self

where Self: Sized + PartialOrd,

Restrict a value to a certain interval.

impl PartialEq for Rstact

fn eq(&self, other: &Rstact) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl PartialOrd for Rstact

fn partial_cmp(&self, other: &Rstact) -> Option<Ordering>

This method returns an ordering between self and other values if one exists.

fn lt(&self, other: &Rhs) -> bool

Tests less than (for self and other) and is used by the < operator.

fn le(&self, other: &Rhs) -> bool

Tests less than or equal to (for self and other) and is used by the <= operator.

fn gt(&self, other: &Rhs) -> bool

Tests greater than (for self and other) and is used by the > operator.

fn ge(&self, other: &Rhs) -> bool

Tests greater than or equal to (for self and other) and is used by the >= operator.

impl Copy for Rstact

impl Eq for Rstact

impl StructuralPartialEq for Rstact