Struct stm32_metapac::vrefbuf::regs::Csr

#[repr(transparent)]
pub struct Csr(pub u32);

VREFBUF control and status register.

Tuple Fields

0: u32

Implementations

impl Csr

pub const fn envr(&self) -> bool

Voltage reference buffer mode enable This bit is used to enable the voltage reference buffer mode.

pub fn set_envr(&mut self, val: bool)

Voltage reference buffer mode enable This bit is used to enable the voltage reference buffer mode.

pub const fn hiz(&self) -> Hiz

High impedance mode This bit controls the analog switch to connect or not the VREF+ pin. Refer to for the mode descriptions depending on ENVR bit configuration.

pub fn set_hiz(&mut self, val: Hiz)

High impedance mode This bit controls the analog switch to connect or not the VREF+ pin. Refer to for the mode descriptions depending on ENVR bit configuration.

pub const fn vrr(&self) -> bool

Voltage reference buffer ready.

pub fn set_vrr(&mut self, val: bool)

Voltage reference buffer ready.

pub const fn vrs(&self) -> Vrs

Voltage reference scale These bits select the value generated by the voltage reference buffer. VRS = 000: VREFBUF0 voltage selected. VRS = 001: VREFBUF1 voltage selected. VRS = 010: VREFBUF2 voltage selected. VRS = 011: VREFBUF3 voltage selected. Others: Reserved Note: Refer to the product datasheet for each VREFBUFx voltage setting value. The software can program this bitfield only when the VREFBUF is disabled (ENVR=0).

pub fn set_vrs(&mut self, val: Vrs)

Voltage reference scale These bits select the value generated by the voltage reference buffer. VRS = 000: VREFBUF0 voltage selected. VRS = 001: VREFBUF1 voltage selected. VRS = 010: VREFBUF2 voltage selected. VRS = 011: VREFBUF3 voltage selected. Others: Reserved Note: Refer to the product datasheet for each VREFBUFx voltage setting value. The software can program this bitfield only when the VREFBUF is disabled (ENVR=0).

Trait Implementations

impl Clone for Csr

fn clone(&self) -> Csr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Csr

fn default() -> Csr

Returns the “default value” for a type.

impl PartialEq for Csr

fn eq(&self, other: &Csr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Csr

impl Eq for Csr

impl StructuralPartialEq for Csr