Struct stm32_metapac::pwr::regs::Csr1

#[repr(transparent)]
pub struct Csr1(pub u32);

PWR control status register 1.

Tuple Fields

0: u32

Implementations

impl Csr1

pub const fn bren(&self) -> bool

Backup regulator enable When set, the backup regulator (used to maintain the backup RAM content in Standby and V_BAT modes) is enabled. If BREN is reset, the backup regulator is switched off. The backup RAM can still be used in Run and Stop modes. However, its content will be lost in Standby and V_BAT modes. If BREN is set, the application must wait till the backup regulator ready flag (BRRDY) is set to indicate that the data written into the SRAM will be maintained in Standby and V_BAT modes.

pub fn set_bren(&mut self, val: bool)

Backup regulator enable When set, the backup regulator (used to maintain the backup RAM content in Standby and V_BAT modes) is enabled. If BREN is reset, the backup regulator is switched off. The backup RAM can still be used in Run and Stop modes. However, its content will be lost in Standby and V_BAT modes. If BREN is set, the application must wait till the backup regulator ready flag (BRRDY) is set to indicate that the data written into the SRAM will be maintained in Standby and V_BAT modes.

pub const fn monen(&self) -> bool

V_BAT and temperature monitoring enable When set, the V_BAT supply and temperature monitoring is enabled. Note: V_BAT and temperature monitoring are only available when the backup regulator is enabled (BREN bit set to 1).

pub fn set_monen(&mut self, val: bool)

V_BAT and temperature monitoring enable When set, the V_BAT supply and temperature monitoring is enabled. Note: V_BAT and temperature monitoring are only available when the backup regulator is enabled (BREN bit set to 1).

pub const fn brrdy(&self) -> bool

Backup regulator ready This bit is set by hardware to indicate that the backup regulator is ready.

pub fn set_brrdy(&mut self, val: bool)

Backup regulator ready This bit is set by hardware to indicate that the backup regulator is ready.

pub const fn vbatl(&self) -> bool

V_BAT level monitoring versus low threshold.

pub fn set_vbatl(&mut self, val: bool)

V_BAT level monitoring versus low threshold.

pub const fn vbath(&self) -> bool

V_BAT level monitoring versus high threshold.

pub fn set_vbath(&mut self, val: bool)

V_BAT level monitoring versus high threshold.

pub const fn templ(&self) -> bool

Temperature level monitoring versus low threshold.

pub fn set_templ(&mut self, val: bool)

Temperature level monitoring versus low threshold.

pub const fn temph(&self) -> bool

Temperature level monitoring versus high threshold.

pub fn set_temph(&mut self, val: bool)

Temperature level monitoring versus high threshold.

Trait Implementations

impl Clone for Csr1

fn clone(&self) -> Csr1

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Csr1

fn default() -> Csr1

Returns the “default value” for a type.

impl PartialEq for Csr1

fn eq(&self, other: &Csr1) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Csr1

impl Eq for Csr1

impl StructuralPartialEq for Csr1