Struct stm32_metapac::sdmmc::regs::Power

#[repr(transparent)]
pub struct Power(pub u32);

SDMMC power control register

Tuple Fields

0: u32

Implementations

impl Power

pub const fn pwrctrl(&self) -> u8

SDMMC state control bits. These bits can only be written when the SDMMC is not in the power-on state (PWRCTRL?11). These bits are used to define the functional state of the SDMMC signals: Any further write will be ignored, PWRCTRL value will keep 11.

pub fn set_pwrctrl(&mut self, val: u8)

SDMMC state control bits. These bits can only be written when the SDMMC is not in the power-on state (PWRCTRL?11). These bits are used to define the functional state of the SDMMC signals: Any further write will be ignored, PWRCTRL value will keep 11.

pub const fn vswitch(&self) -> bool

Voltage switch sequence start. This bit is used to start the timing critical section of the voltage switch sequence:

pub fn set_vswitch(&mut self, val: bool)

Voltage switch sequence start. This bit is used to start the timing critical section of the voltage switch sequence:

pub const fn vswitchen(&self) -> bool

Voltage switch procedure enable. This bit can only be written by firmware when CPSM is disabled (CPSMEN = 0). This bit is used to stop the SDMMC_CK after the voltage switch command response:

pub fn set_vswitchen(&mut self, val: bool)

Voltage switch procedure enable. This bit can only be written by firmware when CPSM is disabled (CPSMEN = 0). This bit is used to stop the SDMMC_CK after the voltage switch command response:

pub const fn dirpol(&self) -> bool

Data and command direction signals polarity selection. This bit can only be written when the SDMMC is in the power-off state (PWRCTRL = 00).

pub fn set_dirpol(&mut self, val: bool)

Data and command direction signals polarity selection. This bit can only be written when the SDMMC is in the power-off state (PWRCTRL = 00).

Trait Implementations

impl Clone for Power

fn clone(&self) -> Power

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Power

fn default() -> Power

Returns the “default value” for a type.

impl PartialEq for Power

fn eq(&self, other: &Power) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Power

impl Eq for Power

impl StructuralEq for Power

impl StructuralPartialEq for Power