Struct stm32_metapac::vrefbuf::regs::Ccr

#[repr(transparent)]
pub struct Ccr(pub u32);

VREFBUF calibration control register.

Tuple Fields

0: u32

Implementations

impl Ccr

pub const fn trim(&self) -> u8

Trimming code The TRIM code is a 6-bit unsigned data (minimum 000000, maximum 111111) that is set and updated according the mechanism described below. Reset: TRIM[5:0] is automatically initialized with the VRS = 0 trimming value stored in the Flash memory during the production test. VRS change: TRIM[5:0] is automatically initialized with the trimming value (corresponding to VRS setting) stored in the Flash memory during the production test. Write in TRIM[5:0]: User can modify the TRIM[5:0] with an arbitrary value. This is permanently disabling the control of the trimming value with VRS (until the device is reset). Note: If the user application performs the trimming, the trimming code must start from 000000 to 111111 in ascending order.

pub fn set_trim(&mut self, val: u8)

Trimming code The TRIM code is a 6-bit unsigned data (minimum 000000, maximum 111111) that is set and updated according the mechanism described below. Reset: TRIM[5:0] is automatically initialized with the VRS = 0 trimming value stored in the Flash memory during the production test. VRS change: TRIM[5:0] is automatically initialized with the trimming value (corresponding to VRS setting) stored in the Flash memory during the production test. Write in TRIM[5:0]: User can modify the TRIM[5:0] with an arbitrary value. This is permanently disabling the control of the trimming value with VRS (until the device is reset). Note: If the user application performs the trimming, the trimming code must start from 000000 to 111111 in ascending order.

Trait Implementations

impl Clone for Ccr

fn clone(&self) -> Ccr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Ccr

fn default() -> Ccr

Returns the “default value” for a type.

impl PartialEq for Ccr

fn eq(&self, other: &Ccr) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Ccr

impl Eq for Ccr

impl StructuralEq for Ccr

impl StructuralPartialEq for Ccr