Struct stm32_metapac::pwr::regs::Cr2

#[repr(transparent)]
pub struct Cr2(pub u32);

Power control register 2

Tuple Fields

0: u32

Implementations

impl Cr2

pub const fn pvde(&self) -> bool

Programmable voltage detector enable Note: This bit is write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: This bit is reset only by a system reset.

pub fn set_pvde(&mut self, val: bool)

Programmable voltage detector enable Note: This bit is write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: This bit is reset only by a system reset.

pub const fn pls(&self) -> Pls

Programmable voltage detector level selection. These bits select the voltage threshold detected by the programmable voltage detector: Note: These bits are write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: These bits are reset only by a system reset.

pub fn set_pls(&mut self, val: Pls)

Programmable voltage detector level selection. These bits select the voltage threshold detected by the programmable voltage detector: Note: These bits are write-protected when the bit PVDL (PVD Lock) is set in the SYSCFG_CBR register. Note: These bits are reset only by a system reset.

pub const fn pvme1(&self) -> bool

Peripheral voltage monitoring 1 enable: V_DDUSB vs. 1.21V

pub fn set_pvme1(&mut self, val: bool)

Peripheral voltage monitoring 1 enable: V_DDUSB vs. 1.21V

pub const fn pvme3(&self) -> bool

Peripheral voltage monitoring 3 enable: V_DDA vs. 1.621V

pub fn set_pvme3(&mut self, val: bool)

Peripheral voltage monitoring 3 enable: V_DDA vs. 1.621V

pub const fn pvme4(&self) -> bool

Peripheral voltage monitoring 4 enable: V_DDA vs. 1.861V

pub fn set_pvme4(&mut self, val: bool)

Peripheral voltage monitoring 4 enable: V_DDA vs. 1.861V

pub const fn usv(&self) -> bool

V_DDUSB USB supply valid This bit is used to validate the V_DDUSB supply for electrical and logical isolation purpose. Setting this bit is mandatory to use the USB FS peripheral. If V_DDUSB is not always present in the application, the PVM can be used to determine whether this supply is ready or not.

pub fn set_usv(&mut self, val: bool)

V_DDUSB USB supply valid This bit is used to validate the V_DDUSB supply for electrical and logical isolation purpose. Setting this bit is mandatory to use the USB FS peripheral. If V_DDUSB is not always present in the application, the PVM can be used to determine whether this supply is ready or not.

Trait Implementations

impl Clone for Cr2

fn clone(&self) -> Cr2

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Cr2

fn default() -> Cr2

Returns the “default value” for a type.

impl PartialEq for Cr2

fn eq(&self, other: &Cr2) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Cr2

impl Eq for Cr2

impl StructuralPartialEq for Cr2