Struct stm32_metapac::adf::regs::Dfltcicr

#[repr(transparent)]
pub struct Dfltcicr(pub u32);

ADF digital filer configuration register 0.

Tuple Fields

0: u32

Implementations

impl Dfltcicr

pub const fn datsrc(&self) -> Datsrc

Source data for the digital filter.

pub fn set_datsrc(&mut self, val: Datsrc)

Source data for the digital filter.

pub const fn cicmod(&self) -> Cicmod

Select the CIC order.

pub fn set_cicmod(&mut self, val: Cicmod)

Select the CIC order.

pub const fn mcicd(&self) -> u16

CIC decimation ratio selection. This bitfield is set and cleared by software.It is used to select the CIC decimation ratio. A decimation ratio smaller than two is not allowed. The decimation ratio is given by (CICDEC+1).

pub fn set_mcicd(&mut self, val: u16)

CIC decimation ratio selection. This bitfield is set and cleared by software.It is used to select the CIC decimation ratio. A decimation ratio smaller than two is not allowed. The decimation ratio is given by (CICDEC+1).

pub const fn scale(&self) -> u8

Scaling factor selection. This bitfield is set and cleared by software. It is used to select the gain to be applied at CIC output. If the application attempts to write a new gain value while the previous one is not yet applied, this new gain value is ignored. Reading back this bitfield informs the application on the current gain value.

pub fn set_scale(&mut self, val: u8)

Scaling factor selection. This bitfield is set and cleared by software. It is used to select the gain to be applied at CIC output. If the application attempts to write a new gain value while the previous one is not yet applied, this new gain value is ignored. Reading back this bitfield informs the application on the current gain value.

Trait Implementations

impl Clone for Dfltcicr

fn clone(&self) -> Dfltcicr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Dfltcicr

fn default() -> Dfltcicr

Returns the “default value” for a type.

impl PartialEq for Dfltcicr

fn eq(&self, other: &Dfltcicr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Dfltcicr

impl Eq for Dfltcicr

impl StructuralPartialEq for Dfltcicr