Struct stm32_metapac::rcc::regs::Radioenr

#[repr(transparent)]
pub struct Radioenr(pub u32);

RCC RADIO peripheral clock enable register

Tuple Fields

0: u32

Implementations

impl Radioenr

pub const fn bbclken(&self) -> bool

2.4 GHz RADIO baseband kernel clock (aclk) enable Set and cleared by software. Note: The HSE oscillator needs to be enabled by either HSEON or STRADIOCLKON.

pub fn set_bbclken(&mut self, val: bool)

2.4 GHz RADIO baseband kernel clock (aclk) enable Set and cleared by software. Note: The HSE oscillator needs to be enabled by either HSEON or STRADIOCLKON.

pub const fn stradioclkon(&self) -> bool

2.4 GHz RADIO bus clock enable and HSE oscillator enable by 2.4 GHz RADIO sleep timer wakeup event Set by hardware on a 2.4 GHz RADIO sleep timer wakeup event. Cleared by software writing zero to this bit. Note: Before accessing the 2.4 GHz RADIO registers the RADIOCLKRDY bit must be checked.

pub fn set_stradioclkon(&mut self, val: bool)

2.4 GHz RADIO bus clock enable and HSE oscillator enable by 2.4 GHz RADIO sleep timer wakeup event Set by hardware on a 2.4 GHz RADIO sleep timer wakeup event. Cleared by software writing zero to this bit. Note: Before accessing the 2.4 GHz RADIO registers the RADIOCLKRDY bit must be checked.

pub const fn radioclkrdy(&self) -> bool

2.4 GHz RADIO bus clock ready. Set and cleared by hardware to indicate that the 2.4 GHz RADIO bus clock is ready and the 2.4 GHz RADIO registers can be accessed. Note: Once both RADIOEN and STRADIOCLKON are cleared, RADIOCLKRDY goes low after three hclk5 clock cycles.

pub fn set_radioclkrdy(&mut self, val: bool)

2.4 GHz RADIO bus clock ready. Set and cleared by hardware to indicate that the 2.4 GHz RADIO bus clock is ready and the 2.4 GHz RADIO registers can be accessed. Note: Once both RADIOEN and STRADIOCLKON are cleared, RADIOCLKRDY goes low after three hclk5 clock cycles.

Trait Implementations

impl Clone for Radioenr

fn clone(&self) -> Radioenr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Radioenr

fn default() -> Radioenr

Returns the “default value” for a type.

impl PartialEq for Radioenr

fn eq(&self, other: &Radioenr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Radioenr

impl Eq for Radioenr

impl StructuralPartialEq for Radioenr