Struct rp_pac::i2c::regs::IcCompParam1

#[repr(transparent)]
pub struct IcCompParam1(pub u32);

Component Parameter Register 1 Note This register is not implemented and therefore reads as 0. If it was implemented it would be a constant read-only register that contains encoded information about the component’s parameter settings. Fields shown below are the settings for those parameters

Tuple Fields

0: u32

Implementations

impl IcCompParam1

pub const fn apb_data_width(&self) -> u8

APB data bus width is 32 bits

pub fn set_apb_data_width(&mut self, val: u8)

APB data bus width is 32 bits

pub const fn max_speed_mode(&self) -> u8

MAX SPEED MODE = FAST MODE

pub fn set_max_speed_mode(&mut self, val: u8)

MAX SPEED MODE = FAST MODE

pub const fn hc_count_values(&self) -> bool

Programmable count values for each mode.

pub fn set_hc_count_values(&mut self, val: bool)

Programmable count values for each mode.

pub const fn intr_io(&self) -> bool

COMBINED Interrupt outputs

pub fn set_intr_io(&mut self, val: bool)

COMBINED Interrupt outputs

pub const fn has_dma(&self) -> bool

DMA handshaking signals are enabled

pub fn set_has_dma(&mut self, val: bool)

DMA handshaking signals are enabled

pub const fn add_encoded_params(&self) -> bool

Encoded parameters not visible

pub fn set_add_encoded_params(&mut self, val: bool)

Encoded parameters not visible

pub const fn rx_buffer_depth(&self) -> u8

RX Buffer Depth = 16

pub fn set_rx_buffer_depth(&mut self, val: u8)

RX Buffer Depth = 16

pub const fn tx_buffer_depth(&self) -> u8

TX Buffer Depth = 16

pub fn set_tx_buffer_depth(&mut self, val: u8)

TX Buffer Depth = 16

Trait Implementations

impl Clone for IcCompParam1

fn clone(&self) -> IcCompParam1

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for IcCompParam1

fn default() -> IcCompParam1

Returns the “default value” for a type.

impl PartialEq for IcCompParam1

fn eq(&self, other: &IcCompParam1) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for IcCompParam1

impl Eq for IcCompParam1

impl StructuralPartialEq for IcCompParam1