Struct Dfltintr 

#[repr(transparent)]
pub struct Dfltintr(pub u32);

This register is used to the integrator (INT) settings.

Tuple Fields

0: u32

Implementations

impl Dfltintr

pub const fn intdiv(&self) -> Intdiv

Integrator output division Set and cleared by software. This bit is used to rescale the signal at the integrator output in order keep the data width lower than 24 bits. - 00: The integrator data outputs are divided by 128 (Default value) - 01: The integrator data outputs are divided by 32 - 10: The integrator data outputs are divided by 4 - 11: The integrator data outputs are not divided This field can be write-protected, please refer to Section 1.4.15: Register protection for details.

pub const fn set_intdiv(&mut self, val: Intdiv)

Integrator output division Set and cleared by software. This bit is used to rescale the signal at the integrator output in order keep the data width lower than 24 bits. - 00: The integrator data outputs are divided by 128 (Default value) - 01: The integrator data outputs are divided by 32 - 10: The integrator data outputs are divided by 4 - 11: The integrator data outputs are not divided This field can be write-protected, please refer to Section 1.4.15: Register protection for details.

pub const fn intval(&self) -> u8

Integration value selection Set and cleared by software. This field is used to select the integration value. - 0: The integration value is 1, meaning bypass mode (default after reset) - 1: The integration value is 2 - 2: The integration value is 3 … - 127: The integration value is 128 This field can be write-protected, please refer to Section 1.4.15: Register protection for details.

pub const fn set_intval(&mut self, val: u8)

Integration value selection Set and cleared by software. This field is used to select the integration value. - 0: The integration value is 1, meaning bypass mode (default after reset) - 1: The integration value is 2 - 2: The integration value is 3 … - 127: The integration value is 128 This field can be write-protected, please refer to Section 1.4.15: Register protection for details.

Trait Implementations

impl Clone for Dfltintr

fn clone(&self) -> Dfltintr

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Dfltintr

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for Dfltintr

fn default() -> Dfltintr

Returns the “default value” for a type.

impl PartialEq for Dfltintr

fn eq(&self, other: &Dfltintr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Dfltintr

impl Eq for Dfltintr

impl StructuralPartialEq for Dfltintr