Struct stm32_metapac::flash::regs::Secbootadd0r

#[repr(transparent)]
pub struct Secbootadd0r(pub u32);

FLASH secure boot address 0 register

Tuple Fields

0: u32

Implementations

impl Secbootadd0r

pub const fn boot_lock(&self) -> bool

Boot lock When set, the boot is always forced to base address value programmed in SECBOOTADD0[24:0] option bytes whatever the boot selection option. When set, this bit can only be cleared by an RDP at level 0.

pub fn set_boot_lock(&mut self, val: bool)

Boot lock When set, the boot is always forced to base address value programmed in SECBOOTADD0[24:0] option bytes whatever the boot selection option. When set, this bit can only be cleared by an RDP at level 0.

pub const fn secbootadd0(&self) -> u32

Secure boot base address 0 The secure boot memory address can be programmed to any address in the valid address range with a granularity of 128 bytes. This bits correspond to address [31:7] The SECBOOTADD0 option bytes are selected following the BOOT0 pin or nSWBOOT0 state. Examples: SECBOOTADD0[24:0] = 0x018 0000: Boot from secure Flash memory (0x0C00 0000) SECBOOTADD0[24:0] = 0x01F F000: Boot from RSS (0x0FF8 0000) SECBOOTADD0[24:0] = 0x060 0000: Boot from secure SRAM1 on S-Bus (0x3000 0000)

pub fn set_secbootadd0(&mut self, val: u32)

Secure boot base address 0 The secure boot memory address can be programmed to any address in the valid address range with a granularity of 128 bytes. This bits correspond to address [31:7] The SECBOOTADD0 option bytes are selected following the BOOT0 pin or nSWBOOT0 state. Examples: SECBOOTADD0[24:0] = 0x018 0000: Boot from secure Flash memory (0x0C00 0000) SECBOOTADD0[24:0] = 0x01F F000: Boot from RSS (0x0FF8 0000) SECBOOTADD0[24:0] = 0x060 0000: Boot from secure SRAM1 on S-Bus (0x3000 0000)

Trait Implementations

impl Clone for Secbootadd0r

fn clone(&self) -> Secbootadd0r

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Secbootadd0r

fn default() -> Secbootadd0r

Returns the “default value” for a type.

impl PartialEq for Secbootadd0r

fn eq(&self, other: &Secbootadd0r) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Secbootadd0r

impl Eq for Secbootadd0r

impl StructuralPartialEq for Secbootadd0r