Struct Config

#[non_exhaustive]
pub struct Config {

    pub clock_source: ClockSel,
    pub baudrate: u32,
    pub data_bits: DataBits,
    pub stop_bits: StopBits,
    pub parity: Parity,
    pub msb_order: BitOrder,
    pub loop_back_enable: bool,
    pub fifo_enable: bool,
    pub invert_tx: bool,
    pub invert_rx: bool,
    pub invert_rts: bool,
    pub invert_cts: bool,
    pub tx_pull: Pull,
    pub rx_pull: Pull,
    pub rts_pull: Pull,
    pub cts_pull: Pull,
}

Config

Fields (Non-exhaustive)

Non-exhaustive structs could have additional fields added in future. Therefore, non-exhaustive structs cannot be constructed in external crates using the traditional Struct { .. } syntax; cannot be matched against without a wildcard ..; and struct update syntax will not work.

clock_source: ClockSel

UART clock source.

baudrate: u32

Baud rate

data_bits: DataBits

Number of data bits.

stop_bits: StopBits

Number of stop bits.

parity: Parity

Parity type.

msb_order: BitOrder

The order of bits in a transmitted/received byte.

loop_back_enable: bool

If true: the TX is internally connected to RX.

fifo_enable: bool

If true: the built-in FIFO is enabled.

invert_tx: bool

If true: invert TX pin signal values (V_DD = 0/mark, Gnd = 1/idle).

invert_rx: bool

If true: invert RX pin signal values (V_DD = 0/mark, Gnd = 1/idle).

invert_rts: bool

If true: invert RTS pin signal values (V_DD = 0/mark, Gnd = 1/idle).

invert_cts: bool

If true: invert CTS pin signal values (V_DD = 0/mark, Gnd = 1/idle).

tx_pull: Pull

Set the pull configuration for the TX pin.

rx_pull: Pull

Set the pull configuration for the RX pin.

rts_pull: Pull

Set the pull configuration for the RTS pin.

cts_pull: Pull

Set the pull configuration for the CTS pin.

Trait Implementations

impl Clone for Config

fn clone(&self) -> Config

Returns a duplicate of the value.

const fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Config

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for Config

fn default() -> Self

Returns the “default value” for a type.

impl PartialEq for Config

fn eq(&self, other: &Config) -> bool

Tests for self and other values to be equal, and is used by ==.

const fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Config

impl Eq for Config

impl StructuralPartialEq for Config