Struct UartTx

pub struct UartTx<'d, M: Mode> { /* private fields */ }

Tx-only UART Driver.

Can be obtained from Uart::split, or can be constructed independently, if you do not need the receiving half of the driver.

Implementations

impl<'d> UartTx<'d, Blocking>

pub fn new_blocking<T: Instance>( peri: Peri<'d, T>, tx: Peri<'d, impl TxPin<T>>, config: Config, ) -> Result<Self, ConfigError>

Create a new blocking tx-only UART with no hardware flow control.

Useful if you only want Uart Tx. It saves 1 pin.

pub fn new_blocking_with_cts<T: Instance>( peri: Peri<'d, T>, tx: Peri<'d, impl TxPin<T>>, cts: Peri<'d, impl CtsPin<T>>, config: Config, ) -> Result<Self, ConfigError>

Create a new blocking tx-only UART with a clear-to-send pin

impl<'d, M: Mode> UartTx<'d, M>

pub fn blocking_write(&mut self, buffer: &[u8]) -> Result<(), Error>

Perform a blocking UART write

pub fn blocking_flush(&mut self) -> Result<(), Error>

Block until transmission complete

pub fn send_break(&self)

Send break character

pub fn busy(&self) -> bool

Check if UART is busy.

pub fn set_config(&mut self, config: &Config) -> Result<(), ConfigError>

Reconfigure the driver

pub fn set_baudrate(&self, baudrate: u32) -> Result<(), ConfigError>

Set baudrate

Trait Implementations

impl<'d, M: Mode> Drop for UartTx<'d, M>

fn drop(&mut self)

Executes the destructor for this type.

impl<'d, M: Mode> SetConfig for UartTx<'d, M>

type Config = Config

The configuration type used by this driver.

type ConfigError = ConfigError

The error type that can occur if set_config fails.

fn set_config(&mut self, config: &Self::Config) -> Result<(), Self::ConfigError>

Set the configuration of the driver.