Struct MacPps0TargetTimeSeconds 

#[repr(transparent)]
pub struct MacPps0TargetTimeSeconds(pub u32);

F70RM Rev. 1 section 51.7.1.47; manual text line 153754.

Tuple Fields

0: u32

Implementations

impl MacPps0TargetTimeSeconds

pub const fn tstrh0(&self) -> u32

PPS Target Time Seconds Register. This field stores the time in seconds. When the timestamp value matches or exceeds both Target Timestamp registers, the MAC starts or stops the PPS signal output and generates an interrupt (if enabled) based on Target Time mode selected for the corresponding PPS output in the MAC_PPS_Control register. If PTGE field of MAC_Timestamp_Control Register is set with Presentation time control set in recovery mode, then these bits indicate the TPT being programmed by the application and in generation mode it indicates the CPT generated at the sampled trigger.

pub const fn set_tstrh0(&mut self, val: u32)

PPS Target Time Seconds Register. This field stores the time in seconds. When the timestamp value matches or exceeds both Target Timestamp registers, the MAC starts or stops the PPS signal output and generates an interrupt (if enabled) based on Target Time mode selected for the corresponding PPS output in the MAC_PPS_Control register. If PTGE field of MAC_Timestamp_Control Register is set with Presentation time control set in recovery mode, then these bits indicate the TPT being programmed by the application and in generation mode it indicates the CPT generated at the sampled trigger.

Trait Implementations

impl Clone for MacPps0TargetTimeSeconds

fn clone(&self) -> MacPps0TargetTimeSeconds

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for MacPps0TargetTimeSeconds

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for MacPps0TargetTimeSeconds

fn default() -> MacPps0TargetTimeSeconds

Returns the “default value” for a type.

impl PartialEq for MacPps0TargetTimeSeconds

fn eq(&self, other: &MacPps0TargetTimeSeconds) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for MacPps0TargetTimeSeconds

impl Eq for MacPps0TargetTimeSeconds

impl StructuralPartialEq for MacPps0TargetTimeSeconds