Struct embassy_stm32::usart::Config

#[non_exhaustive]
pub struct Config {
    pub baudrate: u32,
    pub data_bits: DataBits,
    pub stop_bits: StopBits,
    pub parity: Parity,
    pub detect_previous_overrun: bool,
    pub assume_noise_free: bool,
    pub swap_rx_tx: bool,
    pub invert_tx: bool,
    pub invert_rx: bool,
    /* private fields */
}

Config

Fields (Non-exhaustive)

Non-exhaustive structs could have additional fields added in future. Therefore, non-exhaustive structs cannot be constructed in external crates using the traditional Struct { .. } syntax; cannot be matched against without a wildcard ..; and struct update syntax will not work.

baudrate: u32

Baud rate

data_bits: DataBits

Number of data bits

stop_bits: StopBits

Number of stop bits

parity: Parity

Parity type

detect_previous_overrun: bool

If true: on a read-like method, if there is a latent error pending, the read will abort and the error will be reported and cleared

If false: the error is ignored and cleared

assume_noise_free: bool

Set this to true if the line is considered noise free. This will increase the receiver’s tolerance to clock deviations, but will effectively disable noise detection.

swap_rx_tx: bool

Set this to true to swap the RX and TX pins.

invert_tx: bool

Set this to true to invert TX pin signal values (V_DD =0/mark, Gnd = 1/idle).

invert_rx: bool

Set this to true to invert RX pin signal values (V_DD =0/mark, Gnd = 1/idle).

Trait Implementations

impl Clone for Config

fn clone(&self) -> Config

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Config

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for Config

fn default() -> Self

Returns the “default value” for a type.

impl PartialEq for Config

fn eq(&self, other: &Config) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Config

impl Eq for Config

impl StructuralPartialEq for Config