pub struct Rtc<'d> { /* private fields */ }Expand description
RTC driver.
Implementations§
Source§impl Rtc<'_>
impl Rtc<'_>
Sourcepub fn calibrate(&mut self, clock_drift: f32, period: RtcCalibrationCyclePeriod)
pub fn calibrate(&mut self, clock_drift: f32, period: RtcCalibrationCyclePeriod)
Calibrate the clock drift.
clock_drift can be adjusted from -487.1 ppm to 488.5 ppm and is clamped to this range.
§Note
To perform a calibration when async_prescaler is less then 3, sync_prescaler
has to be reduced accordingly (see RM0351 Rev 9, sec 38.3.12).
Source§impl<'d> Rtc<'d>
impl<'d> Rtc<'d>
Sourcepub const BACKUP_REGISTER_COUNT: usize = RTC::BACKUP_REGISTER_COUNT
pub const BACKUP_REGISTER_COUNT: usize = RTC::BACKUP_REGISTER_COUNT
Number of backup registers of this instance.
Sourcepub fn new(peri: Peri<'d, RTC>, rtc_config: RtcConfig) -> Self
pub fn new(peri: Peri<'d, RTC>, rtc_config: RtcConfig) -> Self
Create a new RTC instance.
The date and time are kept. If the RTC does not already run with the prescalers for
rtc_config, they are written, which restarts the current second.
With the low-power feature and a time driver that is not a low-power timer,
embassy_stm32::init already configures the RTC with Config::rtc to measure the time
spent in Stop mode. Pass the same configuration here to keep it.
Sourcepub fn reader(&self) -> RtcReader<'d>
pub fn reader(&self) -> RtcReader<'d>
Get a reader for the current date and time.
Use it to read the time from other tasks, while the Rtc is used to set it.
Sourcepub fn read_raw(&self) -> RawDateTime
pub fn read_raw(&self) -> RawDateTime
Read the raw contents of the RTC calendar registers. See RtcReader::read_raw.
Sourcepub fn set_raw(&mut self, t: RawDateTime)
pub fn set_raw(&mut self, t: RawDateTime)
Write raw values to the RTC calendar registers.
See RawDateTime: the values are not validated, and subsecond is ignored. This function sets subseconds to 0.
Sourcepub fn synchronize(&mut self, shift: f32)
pub fn synchronize(&mut self, shift: f32)
Synchronize to a remote clock with a high degree of precision.
shift should be adjusted from -1 to 1 second.
Sourcepub fn get_daylight_savings(&self) -> bool
pub fn get_daylight_savings(&self) -> bool
Check if daylight savings time is active.
Sourcepub fn set_daylight_savings(&mut self, daylight_savings: bool)
pub fn set_daylight_savings(&mut self, daylight_savings: bool)
Enable/disable daylight savings time.
Sourcepub fn read_backup_register(&self, register: usize) -> Option<u32>
pub fn read_backup_register(&self, register: usize) -> Option<u32>
Sourcepub fn write_backup_register(&self, register: usize, value: u32)
pub fn write_backup_register(&self, register: usize, value: u32)
Set content of the backup register.
The registers retain their values during wakes from standby mode or system resets. They also retain their value when Vdd is switched off as long as V_BAT is powered.
Does not write to the register. Use the TAMP peripheral instead.