Struct Wucr

#[repr(transparent)]
pub struct Wucr(pub u32);

PWR wakeup configuration register

Tuple Fields

0: u32

Implementations

impl Wucr

pub fn wupen(&self, n: usize) -> bool

enable wakeup pin WUPx These bits are set and cleared by software. Note: an additional wakeup event is detected if WUPx pin is enabled (by setting the WUPENx bit) when WUPx pin level is already high when WUPPx selects rising edge, or low when WUPPx selects falling edge.

pub fn set_wupen(&mut self, n: usize, val: bool)

enable wakeup pin WUPx These bits are set and cleared by software. Note: an additional wakeup event is detected if WUPx pin is enabled (by setting the WUPENx bit) when WUPx pin level is already high when WUPPx selects rising edge, or low when WUPPx selects falling edge.

pub fn wupp(&self, n: usize) -> Wupp

wakeup pin polarity bit for WUPx These bits define the polarity used for event detection on WUPx external wakeup pin.

pub fn set_wupp(&mut self, n: usize, val: Wupp)

wakeup pin polarity bit for WUPx These bits define the polarity used for event detection on WUPx external wakeup pin.

pub fn wuppupd(&self, n: usize) -> Wuppupd

wakeup pin pull configuration for WKUPx These bits define the I/O pad pull configuration used when WUPENx = 1. The associated GPIO port pull configuration must be set to the same value or to 00. The wakeup pin pull configuration is kept in Standby mode.

pub fn set_wuppupd(&mut self, n: usize, val: Wuppupd)

wakeup pin pull configuration for WKUPx These bits define the I/O pad pull configuration used when WUPENx = 1. The associated GPIO port pull configuration must be set to the same value or to 00. The wakeup pin pull configuration is kept in Standby mode.

Trait Implementations

impl Clone for Wucr

fn clone(&self) -> Wucr

Returns a duplicate of the value.

const fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Default for Wucr

fn default() -> Wucr

Returns the “default value” for a type.

impl PartialEq for Wucr

fn eq(&self, other: &Wucr) -> bool

Tests for self and other values to be equal, and is used by ==.

const fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Wucr

impl Eq for Wucr

impl StructuralPartialEq for Wucr